Hydroflow Hydroflow HS 38A Water Conditioner (Professional Installer Systems) |
Other Parts |
|
|
|
|
|
|
|
 |
You are here  |
Hydroflow Hydroflow HS 38A Water Conditioner (Professional Installer Systems) for £114.97 |
 |
|
|
|
|
|
|
 |
|
| |
Hydroflow Hydroflow HS 38A Water Conditioner (Professional Installer Systems).
Is HydroFLOW easy to install?The unit simply clips to the pipe and is plugged into the electric supply and switched on. Installation is very straightforward
Can I still drink the water?HydroFLOW does not change the chemical composition of the water in any way. It works purely on a physical basis leaving the water completely drinkable. Essential minerals are retained in the water. Unlike water softeners it is not necessary to provide a separate untreated drinking supply.
Will HydroFLOW descale as well as prevent scale?Yes although it may be a gradual process over a period of months. The way in which HydroFLOW prevents limescale from forming on pipework also increases the solvicity of water - meaning that any limescale which had already formed will gradually dissolve. However not all scale is limescale. Some scale cannot be dissolved and can only be removed by acid cleaning. Once a system is cleaned it is less likely to scale up again.
Where should I fit the HydroFLOW?Due to HydroFLOW's unique technology we recommend that the unit be installed on the cold feed to the heat exchanger. In the case of a traditional gravity-fed system this would be the down pipe between the cold water storage tank and the hot water cylinder. With a mains pressure system the unit should be fitted on the cold feed just before it enters the heat exchanger.
What is the difference between the HS34 and HS38 units?The HS34 has a 5-volt output and the HS38 has an 8-volt output. This simply means the signal from an HS38 will travel further. Therefore if you are using the unit to protect a particular appliance or you have a simple plumbing system an HS34 is more than sufficient. For more complex system such as boiler and cylinder systems or those already badly scaled it is advisable to fit an HS38.
How much does HydroFLOW cost to run?Less than ninety pence a year - HydroFLOW actually uses 12 volts AC via a transformer connected to the mains at a maximum power of 1.2 Watts.
How can I tell ... |
|
 |
£114.97 Incl VAT (EU)
£97.85 Excl VAT (Outside EU)
|
|
|
|
|
|
 |
Information |
 |
 |
Optimised for viewing on Internet Explorer 5 or later at 1024 X 768.
Managed by eDirectory.co.uk copyright 1997 - 2008 |
 |
|
